Custom 3D Printed Uniform Badges: From Concept to Finished Run
By 3 Boyz Printz · November 6, 2026
Not every project starts with a finished 3D file. Some start with an email and a picture. This one began when the Chief of Patrol for the Mahoning Valley Sanitary District (MVSD) asked whether we could make a custom uniform badge for the District's Resource Officers.
MVSD sent over an image of the proposed badge along with two big questions: could we turn the artwork into a 3D model, and could our equipment handle the detail? The design had raised lettering, detailed building features and a gold-and-silver finish, and it needed to hold up to daily uniform wear.
Their plan was a smart one. They wanted to start with one actual-size prototype and consider a small order if it looked right. They even asked us to speak up if the fine details called for a different printing process.
From flat artwork to a 3D model
A printer can't do much with a picture, so the first job was building a 3D model from the artwork. Every element needed its own height, from the raised lettering to the building and its windows, the banners, the stars and the fine rays across the silver background.
To see how close we'd come, we held a test print up next to the original image.
The original image
Our 3D printThree prototypes to choose from
Rather than guess which finish MVSD would like best, we printed three versions in PLA so they could see and hold the differences. Two came off a 0.4mm nozzle, one with an epoxy coating and one without, and the third came off a finer 0.2mm nozzle with epoxy. The smaller nozzle can print finer detail, while the epoxy adds a smooth, glossy, domed finish.
After comparing all three, MVSD went with the 0.4mm print with the epoxy coating.
A problem we only found in production
Prototypes answer the big questions, but making a batch can turn up things a single piece won't. Once we moved into the production run, we found it was hard to keep the epoxy from spilling over the sides of the badges.
Instead of fighting it on every badge, we fixed the cause. We updated the design with a small lip around the edge to contain the pour. You'd hardly notice it, but it made the coating far easier to get right every time.
The finished badges
With the lip in place, the epoxy stayed right where it belonged, leaving each badge with a clean, glossy, domed finish over the gold and silver detail. To make them ready for daily wear, we epoxied a 1.5-inch locking bar pin to the back of each one so it fastens securely.
Most importantly, MVSD was very happy with the result.
Have a project in mind?
You don't need a 3D file or a huge order to get started. Artwork or a good image can be enough, and we can work through prototypes with you before the full run. Read how contract 3D printing works, or request a quote and tell us what you're trying to make.
